When: Tues., November 19, 2019
Time: 10:00AM - 1:00PM
Where: Teledyne LeCroy
765 Sycamore Dr.
Milpitas, CA 95035
Power rail measurements offer a few unique challenges that typical signal measurements do not. These arise from the low level voltages on top of large DC levels, the low impedance source, the high bandwidth and the potential of rf pick up from non-coaxial probes.
One goal of PDN design is to engineer the power delivery network to deliver low noise DC voltages to the power rails on the die. Discussion will include how to design the PDN to meet a target profile.
The final test of the power noise is measuring the on-die power rail noise directly. Using a simple technique, we can directly measure the on-die power rail noise for the various on die rails.
In this seminar, we will show how accurate, high bandwidth measurements of power rail voltages are sensitive to artifacts and how to overcome them so you can get a more accurate and realistic measure of your power rails whether on board, or on-die.
We will look at examples of measuring both the on-board and the on-die power noise and how some of the important design features affect this noise.
Cost: FREE, registration is required to hold your seat.
Secrets of Successful On-Board, On-Die Power Rail Measurements, and PDN Impedance Design.
PLEASE NOTE: All visitors must provide valid government photo identification prior to gaining access to a Teledyne facility. This can be in the form of a driver's license or passport.