AVAILABLE ON-DEMAND
This webinar was originally held on December 13, 2023.
Fundamentals of EMI Tutorial:
3 Simple Pre-compliance Tests You Should Be Performing
Avoid expensive EMI problems that prevent your product from shipping on time, and don’t wait until final certification test to find an EMI problem in your design. Instead, design them out of your product so they do not occur, and then do initial EMI testing as early in the product development cycle as possible. In this webinar, we will describe three common design features to avoid to reduce EMI problems and demonstrate pre-compliance tests that will identify problems before you submit your product for an expensive EMI compliance test.
Topics to be covered in this webinar:
- Why it is hard to pass an EMI certification test
- Three common design features that cause EMI failures
- Three oscilloscope measurement techniques to identify potential EMI problems
- Two special probes you should be using for EMI pre-compliance testing
- How to set up and use real time spectral analysis to find EMI problems
Who should attend? Hardware engineers, circuit designers, PCB designers, test engineers, EMC engineers, and embedded systems engineers.
What attendees will learn? You will learn the three most important design principles to avoid EMI problems and best measurement practices to find potential problems with a scope.
Presented by: Eric Bogatin, Teledyne LeCroy Fellow and Professor, ECEE Univ of Colorado, Boulder